Cubeitmod 4.91 Print Errors
Posted: 20 Nov 2016, 22:20
I have trying to get my cubex duo to print with kisslicer for a couple weeks now and can not figure out why i am getting the results that i am. I hav tried to print the "finetune" part file but it always screws up on the same wall no matter how i orientate it or no matter what setting i use. I am printing with 1.75mm abs so i know that could be causing some issues but i doubt thats why it wont print this side. i have the original hot end and a heated bed set to 110c. The entire printer is enclosed. also none of the fans turn on during any part of the print.They dont turn on with the cubex software or with kisslicer but i have seen the 2 print fans on when i was running the extruder to unclog it but that was the only time. any tips to make the fans work and to get a proper print would be much appreciated!