kisslicertalk.com

Double-sided adhesive:
I print with my BFB 3D Touch (Single) mainly PLA material that I Lacquer then. The pressure bed I exchanged by an aluminum plate (better flatness). Each time I use double-sided adhesive without "Raft". I so far not received a print would not hold.

KIsslicer is the first choice for my printer at the moment. Had last Simplify3D tried, but with limited success.

What's the name of your double sided adhesive?

Tesa (universal)

In fact, this is the same way the other tape solutions work.
The difference is, that the single sided tapes take a bit of the glue with them on the non sticky side
instead of being glues completely.
The glue stick is the same thing.

My question is, how sticky is is that sticky tape side. Can you remove the printed item with ease?

Eddy

For small parts, the tape goes away well. From glue little remains. It is best to dab the remote tape afterwards the sticky part from. This makes it possible to remove almost all adhesive residue.