kisslicertalk.com

Hi, why when I activate the raft, if I have a layer of 0.2mm makes me a layer of 0.5mm raft ?
Thanks

Hello

Because layer height of first printed layer is "your layer height" + "z gap parameter in Support / Object interface setting" + "Printer/Hardware/Bed Roughness parameter"

For the second layer it is just "your layer height" + "z gap parameter in Support / Object interface setting"

If You do not want gap between raft and object, You have to set Z Gap to zero.

If You want to use raft and also support, well You'd have to find compromise between object/support gap and raft/object gap. Unfortunately it is controlled by one parameter.

Cheers

Thanks And sorry if i don't have answer before