Page 3 of 3
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 03 Mar 2016, 07:36
by rantzaus
Hi..
When using the old version 1.4.5.10 there os no problem. I have installed the GRM sensor for a more constant z.gab...
I have tried to change the flowtweak of the support, and that did help a lot...
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 03 Mar 2016, 07:39
by rantzaus
I did change the wifth to 0.7mm and the raft is very nice and need.
Thanks!!
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 22 Jun 2016, 06:23
by Mimban
Hugues wrote:Several possibilities :
- Increase your flowtweak in material tab and check with your calliper the thickness to accord with your nozzle 0.5
- Check your extruder motor and if you've a clicking sound, try to increase your extruder voltage.
Hi Hugues. Can you help me how / where can i increase the voltage? After a few week my printer started the clicking. Thank you.
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 22 Jun 2016, 13:02
by Mimban
Nevermind. Finaly i found.
Mimban wrote:Hugues wrote:Several possibilities :
- Increase your flowtweak in material tab and check with your calliper the thickness to accord with your nozzle 0.5
- Check your extruder motor and if you've a clicking sound, try to increase your extruder voltage.
Hi Hugues. Can you help me how / where can i increase the voltage? After a few week my printer started the clicking. Thank you.