Page 2 of 2
Re: Seam hiding
Posted: 02 Jun 2015, 11:23
by Ultim - Yoann
Hi,
Material : PLA E-sun
Hot End : E3D V6 0.4mm with 0.45mm in Kisslicer extrusion width parameter
Layer : 0.2mm
Print Temp : 220°
Medium speed print (~30mm/s)
- Seam Hiding.jpg (14.55 KiB) Viewed 4249 times
- Destring.jpg (14.5 KiB) Viewed 4249 times
Re: Seam hiding
Posted: 06 Jun 2015, 00:30
by inventabuild
Looks great. Do you use bowden or direct drive extruder? If bowden, how long are the PTFE tubes and did you have strings?
Re: Seam hiding
Posted: 26 Jul 2015, 22:08
by Epop
holy jesus... retract & prime might be an issue as will Z lift.
a picture of what I'm getting ATM (just slightly under extruded at path start)... the seam is just above the flash highlight
- PLA natural .2mm layer height
- S-plug-PLA 2mm layer.jpg (76.69 KiB) Viewed 4165 times
If you want settings/more pictures etc... let me know.
Re: Seam hiding
Posted: 28 Jul 2015, 15:42
by de_kaminski
Ultim - Yoann: Das ist Lecker!!
Very nice result!
Re: Seam hiding
Posted: 24 Mar 2016, 15:40
by jaydie
Ultim - Yoann wrote:Hi,
Material : PLA E-sun
Hot End : E3D V6 0.4mm with 0.45mm in Kisslicer extrusion width parameter
Layer : 0.2mm
Print Temp : 220°
Medium speed print (~30mm/s)
Seam Hiding.jpg
Destring.jpg
Seam Exemple.jpg
Trying these setting now...
Re: Seam hiding
Posted: 29 Apr 2016, 17:04
by voelkerp
I'm also having a bad time with this issue. It wasn't a problem before and I'm not sure when it changed but I can't get rid of it now. I'm using kisslicer 1.5.2.22 64 bit. I've tried reducing the seam hiding gap and depth to 0.1 and also have done many iterations with suck and push but when I reduce the push by enough to see a difference in that starting bubble, the remaining extrusion for that layer suffers significantly.
