Page 2 of 2
Re: Top infill not touching perimeters
Posted: 26 Aug 2018, 08:13
by frozen.rabbit
This is on every layer for me, sparse and solid infill, not just top layer.
Re: Top infill not touching perimeters
Posted: 26 Aug 2018, 08:51
by pjr
frozen.rabbit wrote:This is on every layer for me, sparse and solid infill, not just top layer.
Every layer except the first?
Peter
Re: Top infill not touching perimeters
Posted: 26 Aug 2018, 23:07
by frozen.rabbit
I'm seeing it on all layers.
Re: Top infill not touching perimeters
Posted: 27 Aug 2018, 04:53
by pjr
frozen.rabbit wrote:I'm seeing it on all layers.
OK, thanks. Will note that also.
Peter
Re: Top infill not touching perimeters
Posted: 27 Aug 2018, 10:43
by frozen.rabbit
Print test for me confirmed that an overlap value of 1.9 gives equivalent results as a value of 1 in prior releases.
Re: Top infill not touching perimeters
Posted: 28 Aug 2018, 04:15
by pjr
Layer 1:
- Image3.png (48.13 KiB) Viewed 4013 times
Layer 2:
- Image4.png (51.46 KiB) Viewed 4013 times
To me, the first layer looks about how I would expect, whereas layer 2 does not.
Peter
Re: Top infill not touching perimeters
Posted: 28 Aug 2018, 07:40
by frozen.rabbit
You're right, 1st layer is right with overlap of 1, but every layer after is not overlapping the perimeter.
Re: Top infill not touching perimeters
Posted: 28 Aug 2018, 19:26
by sinned6915
There is an issue with the Loop/Solid Infill slider under Profile -> Printer - >Hardware.
It is marked as 0-2 now where it used to be 0-1.
Add 1.0 to your old values and it should be the same as it was in 1.6.3