Page 2 of 3
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 09:14
by rantzaus
Will test with the new values tomorrow.
Does these settings work with 0.3 and 0.5 nozzles?
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 09:35
by Giovanni V.
rantzaus wrote:Will test with the new values tomorrow.
Does these settings work with 0.3 and 0.5 nozzles?
No, a larger nozzle requires higher values because the fused plastic can easily flow through.
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 09:40
by rantzaus
Okay.
I'll change the values tomorrow.
Does the actual values seem OK for the 0.3 nozzle?
The prints are okay...
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 11:02
by Giovanni V.
rantzaus wrote:Okay.
I'll change the values tomorrow.
Does the actual values seem OK for the 0.3 nozzle?
The prints are okay...
It's impossible to tell if it's ok or not because M227/228 are also related to material you're using.
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 11:02
by Giovanni V.
rantzaus wrote:Okay.
I'll change the values tomorrow.
Does the actual values seem OK for the 0.3 nozzle?
The prints are okay...
It's impossible to tell if it's ok or not because M227/228 are also related to material you're using.
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 11:13
by rantzaus
Do they varying from spool to spool or only from manufacturer to manufacturer?
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 12:14
by Giovanni V.
rantzaus wrote:Do they varying from spool to spool or only from manufacturer to manufacturer?
manufacturer to manufacturer, but you may have small differences if you change the color from the same manufacturer
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 02 Mar 2016, 13:25
by rantzaus
Now when mentioning the color. Is there a color or some colors that are better then others?
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 03 Mar 2016, 07:17
by rantzaus
Hey Again
I have tried the new settings. I still have problems with the Raft in kiss 1.5 Beta 2.22. See picture.
Re: Flow/Printing Problems - CubeX and Stock Nozzle
Posted: 03 Mar 2016, 07:28
by Giovanni V.
rantzaus wrote:Hey Again
I have tried the new settings. I still have problems with the Raft in kiss 1.5 Beta 2.22. See picture.
The pic shows too much gap or too little RPM.
Reduce the zgap and/or increase the raft width.
It's difficult to say just by looking at the picture but I think is more a problem of zgap.