Kisslicer from command line on windows

Post Reply
masterofreality
Posts: 2
Joined: 25 Jun 2019, 01:43

Kisslicer from command line on windows

Post by masterofreality »

Hello.
I'm using Kisslicer for automation slicing process of 3d printing small factory.

I Run kisslicer from console in windows from external application service. (with -hidegui and etc arguments )

Please! Tell me, How can i ignore this message programmaticaly (without pressing the button) for ex. is there are settings or any workaround ?

Image

Thank you
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Kisslicer from command line on windows

Post by pjr »

Could you not simply open the Settings/Misc tab and increase the RAM Warning to something more sensible?
Capture.PNG
Capture.PNG (26.52 KiB) Viewed 908 times
Peter
masterofreality
Posts: 2
Joined: 25 Jun 2019, 01:43

Re: Kisslicer from command line on windows

Post by masterofreality »

Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Kisslicer from command line on windows

Post by pjr »

masterofreality wrote:Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?
Yeah, I thought that may be the case. Just checking. Hopefully I will have a response shortly.

Peter
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Kisslicer from command line on windows

Post by pjr »

This is now on the fault list and will be included in a future release.

Peter
Post Reply