Hello.
I'm using Kisslicer for automation slicing process of 3d printing small factory.
I Run kisslicer from console in windows from external application service. (with -hidegui and etc arguments )
Please! Tell me, How can i ignore this message programmaticaly (without pressing the button) for ex. is there are settings or any workaround ?
Thank you
Kisslicer from command line on windows
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Kisslicer from command line on windows
Could you not simply open the Settings/Misc tab and increase the RAM Warning to something more sensible?
Peter
Peter
-
- Posts: 2
- Joined: 25 Jun 2019, 01:43
Re: Kisslicer from command line on windows
Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Kisslicer from command line on windows
Yeah, I thought that may be the case. Just checking. Hopefully I will have a response shortly.masterofreality wrote:Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?
Peter
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Kisslicer from command line on windows
This is now on the fault list and will be included in a future release.
Peter
Peter