Good impressions in Ender 3!

Post Reply
ismaelzsilva
Posts: 7
Joined: 07 Feb 2019, 07:32

Good impressions in Ender 3!

Post by ismaelzsilva »

Hi! After a few tips of @pjr i have been able to print in a decent print quality.
0.2 layer thick, infill 10%(?)m and some tweaks. When i finish configuring Kisslicer i will post the configurations in the Hardware subforum.
Check the pictures:

Image

Image

Image

Image
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Good impressions in Ender 3!

Post by pjr »

YAY!!!

Aztech Chief. :D :D :D

There's also a nice multi-filament version which I printed a long time ago :)

That's brilliant, well done. You should be able to print this model without either the prime tower or brim.

Peter
ismaelzsilva
Posts: 7
Joined: 07 Feb 2019, 07:32

Re: Good impressions in Ender 3!

Post by ismaelzsilva »

pjr wrote:YAY!!!

Aztech Chief. :D :D :D

There's also a nice multi-filament version which I printed a long time ago :)

That's brilliant, well done. You should be able to print this model without either the prime tower or brim.

Peter
Thnx! I was wondering if the prim tower can be resized or configured, or it is fixed?
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Good impressions in Ender 3!

Post by pjr »

ismaelzsilva wrote:I was wondering if the prim tower can be resized or configured, or it is fixed?
I don't believe that you need the Prime Tower at all. That is used to prime the nozzle (ie during a tool change) and can be turned off (set to "No Prime Structure") for single filament prints.

Peter
Post Reply