Top infill not touching perimeters
-
- Posts: 132
- Joined: 17 Nov 2014, 09:20
Re: Top infill not touching perimeters
This is on every layer for me, sparse and solid infill, not just top layer.
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Top infill not touching perimeters
Every layer except the first?frozen.rabbit wrote:This is on every layer for me, sparse and solid infill, not just top layer.
Peter
-
- Posts: 132
- Joined: 17 Nov 2014, 09:20
Re: Top infill not touching perimeters
I'm seeing it on all layers.
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Top infill not touching perimeters
OK, thanks. Will note that also.frozen.rabbit wrote:I'm seeing it on all layers.
Peter
-
- Posts: 132
- Joined: 17 Nov 2014, 09:20
Re: Top infill not touching perimeters
Print test for me confirmed that an overlap value of 1.9 gives equivalent results as a value of 1 in prior releases.
- pjr
- Posts: 692
- Joined: 05 May 2015, 10:27
- Location: Kamnik, Slovenia
Re: Top infill not touching perimeters
Layer 1:
Layer 2:
To me, the first layer looks about how I would expect, whereas layer 2 does not.
Peter
Layer 2:
To me, the first layer looks about how I would expect, whereas layer 2 does not.
Peter
-
- Posts: 132
- Joined: 17 Nov 2014, 09:20
Re: Top infill not touching perimeters
You're right, 1st layer is right with overlap of 1, but every layer after is not overlapping the perimeter.
-
- Posts: 55
- Joined: 28 Nov 2017, 10:06
Re: Top infill not touching perimeters
There is an issue with the Loop/Solid Infill slider under Profile -> Printer - >Hardware.
It is marked as 0-2 now where it used to be 0-1.
Add 1.0 to your old values and it should be the same as it was in 1.6.3
It is marked as 0-2 now where it used to be 0-1.
Add 1.0 to your old values and it should be the same as it was in 1.6.3