I decided to try KISSlicer after being frustrated S3D and Cura. Lots of wasted plastic on redos of prints.
My printer is a Wanhao Di3 with Repetier on Melzi board. Went through the setup and a couple of the wizards, and printed the test cube and was AMAZED at the quality of the print- and I have PETG in the machine to boot!
PID parameters- On one of the wizards or setups, I though there was a place to put in the PID parameters. I can not find it now and I wanted to RTFM but no luck.
I can not find the manual at any of the links in the forum... they are all 404. Did it get moved somewhere?
Am I imagining this? Is there a place to put in the PID parameters?
Thanks in advance
Dennis
