Beefeater wrote:Printing a wall 2mm wide at the base and tapering to 0.25mm, with W=0.5mm nominal extrusion width. As the wall narrows, the path switches from 2 loops to 1 loop and a crown path, then 1 loop, then just the crown path. .STL and .KSP attached.
1. Kisslicer varies the width of the crwon path from 0.5W to 1.5W, but it is always displayed at 1.0W width in the preview. So one has to read G-code to know how Kisslicer decided to handle each situation.
2. Near the top, the preview shows the crown path in purple even if "color paths by extruder" is chosen. Near the bottom, crown paths are colored correctly by extruder.
BTW, "Unsupported paths - Slows speed but not extrusion rate (BFB)" is fixed in RC1.
That's weird about the colors, but for the rest, crowning isn't that sophisticated yet...it only has a single width for a single path (supposedly at the average thickness for that crowning path, and limited from 50% to 150% of the extrusion width). If there are multiple crown paths they can each have a distinct width.
thanks,
Jonathan