Imperfections

Discuss general topics that don't suit another sub-forum
Post Reply
alil2096
Posts: 38
Joined: 08 Sep 2015, 16:50

Imperfections

Post by alil2096 »

Hi all!
I'm here because i'm a little problem with every release of ks.. The problems are a lot, but i think the very problem is on my settings. I post a picture for a better understend.
The most problems are at the end of layer and when there is a hole.
I use a PRO version of KS 2 rc for widnwos, but i have try with a mac and the problem persists.
Link a photo
alil2096
Posts: 38
Joined: 08 Sep 2015, 16:50

Re: Imperfections

Post by alil2096 »

You have a lot of beer payed!!
Thanks a lot ;)
I can to change the acceleration, beacuse now they are 700 mm/s..I must do same test
Marine
Posts: 1
Joined: 19 Apr 2017, 17:20

Re: Imperfections

Post by Marine »

I would recommend you to check some proper guides on how to use your 3d printer.
I can be a problem of a concrete model of printer, but first of all take a look at this guide, it may help you a lot : http://3dinsider.com/3d-printing-guide/
Super
Post Reply