CubeX PLA fans not running?

[pingu]

Hi,

running Kisslicer/Cubeitmod and trying out PLA. The fans are not running so the PLA gets a bit burnt. I see the fan g-gode is checked in Kisslicer.

Any ideas appriciated!

[sadclown706]

Have you verified the fans are working?
Press "PJ-CONN" the fans should turn on.

[pingu]

Good call thanks!

They do work, but there is a Code 13 error present when I try the PJ-Con. Then the fans spin. So code 13..hmm..

[pingu]

Now PJ-Con colling fans turn on, but when I print PLA - no fans.

[Giovanni V.]

Now PJ-Con colling fans turn on, but when I print PLA - no fans.

How much do you have for Fan Z [mm] into Matl table ?
Under Printer / Firmware is Fan ON = M106 ?

[pingu]

Giovanni:

The mtrl settings are default. How should I change it?

Thanks.

[Giovanni V.]

Send some screen shots of your settings

Giovanni:

The mtrl settings are default. How should I change it?

Thanks.

[moo00se]

How much do you have for Fan Z [mm] into Matl table ?
The default is 200
Under Printer / Firmware is Fan ON = M106 ? Yes for me.

I have installed all of this fore the first time. I struggled with using 491 before i found this thread My first print with 6.05 the part fans did not run. The part is 12mm tall.

[Giovanni V.]

How much do you have for Fan Z [mm] into Matl table ?
The default is 200
Under Printer / Firmware is Fan ON = M106 ? Yes for me.

I have installed all of this fore the first time. I struggled with using 491 before i found this thread My first print with 6.05 the part fans did not run. The part is 12mm tall.

If you set "Fan Z = 0 " the fan will start from first layer, if you set FanZ =0.4 and you have 0.2 for layer thickness the fan will not work for the first 2 layers and after the fan will be turned on.

[moo00se]

Thanks!