Min Layer Ignored?

Post Reply
Zilla
Posts: 2
Joined: 24 Jan 2017, 20:17

Min Layer Ignored?

Post by Zilla »

I'm brand new to the forum, but have been using KISSlicer for about 3 months on a Rostock V3. I've been trying to sort out some stringing problems in my test prints to calibrate new materials. No matter how much I increase min layer time to let the fans work, it seems to have no effect. I started with 10, then went to 20, now at 30, but many of my small test prints finish each layer in much less than 10 seconds (small icicle/column objects). Is there something obvious I'm missing in the settings? Thanks!

Zilla
Zilla
Posts: 2
Joined: 24 Jan 2017, 20:17

Re: Min Layer Ignored?

Post by Zilla »

Sorry--meant to post this in troubleshooting...
Post Reply