Toggle support material base interface layer

[frozen.rabbit]

I STILL want to be able to disable the bottom support interface layer.

The bottom interface is pretty much impossible to remove when support is generated over a flat surface of the model.

I have been using Beta 1.1.0.5 from January 2013 when I have a model that this is an issue with.

[Davide Ardizzoia]

Why you aren't using latest betas ?
You have z gap to play with...
Brgds
Davide Ardizzoia

[frozen.rabbit]

For most of my prints, I am using the latest betas.

I only use Beta 1.1.0.5 when I have a model that needs support above flat parts of the model. Beta 1.1.0.5 does not generate an interface at the base of the support material.

Z gap only controls the top interface to model gap, not the base support interface.

[Davide Ardizzoia]

Are you using two extruders ?

Best Regards
Davide Ardizzoia

[frozen.rabbit]

single extruder, reducing flow gain in support settings doesn't seem to help.

I requested being able to toggle this when Jonathan first added it.