After messing around with the new KS the printer is now giving me a T12 error code when i start heating the extruder...any thoughts?
Thanks
Initial rate of change low
-
- Posts: 38
- Joined: 23 Jan 2015, 00:48
- Location: South Ogden, Utah(USA)
Re: Initial rate of change low
Page 83 of the manual for a CubePro says
T12 is extruder 1
Error: Idler stall
Cause: blocked extruder/tangled cartridge
or
Error: "initial rate of change low"(?)
Cause: -contact support
No idea what the initial rate of change is... Hope this helps
T12 is extruder 1
Error: Idler stall
Cause: blocked extruder/tangled cartridge
or
Error: "initial rate of change low"(?)
Cause: -contact support
No idea what the initial rate of change is... Hope this helps
3D Systems - CubePro Trio (triple head printer)
--Modified to RepRap standards using Duet and the x4 expansion
-e3d Kraken, heated bed added.
Kisslicer Pro licenced
--Modified to RepRap standards using Duet and the x4 expansion
-e3d Kraken, heated bed added.
Kisslicer Pro licenced
-
- Posts: 21
- Joined: 30 Jan 2015, 11:51
Re: Initial rate of change low
At first i though it was the filament blocking the extruder so i dismantled it to check it out and it was fine, after many trys i took off 2 cartridges and tried to print something with just one and it worked... Idont know wtf happened but it's fine now