Jumps on first layer

[yrabbit]

I noticed that the first layer sometimes has stripes and as it turned out it's not the fault of variable filament thickness - it's inherent in GCode generated by Kisslicer
Here is a link to a small video that demonstrates the movements on the first layer:
https://yrabbit.cyou/extra/kisslicer/fi ... -jumps.mp4

This is a simple model to test the quadarticity of the printer, and in this case it's not critical, but in more responsible products I'd like to have a smooth first layer, which is difficult with jumps like this.

And frankly I don't see any reason to depart from the usual line to line filling and jumping back and forth.

shot-0.png (106.74 KiB) Viewed 1106 times

[yrabbit]

And btw in reality:

printer.jpg (3.42 MiB) Viewed 1104 times