Jumps in supports

[yrabbit]

Hello
When printing the first support layer, Kisslicer suddenly decides to make a small jump. What is the reason for this? And yes the printer really jerks at this point.
Unfortunately I couldn't find this place in GCode quickly because I didn't understand how to interpret the ‘GCode 0.200’ above the scroller.

supports

shot-4.png (129.82 KiB) Viewed 499 times

supports

shot-5.png (127.4 KiB) Viewed 499 times

g-code text

shot-6.png (122.36 KiB) Viewed 499 times

G-CODE : https://yrabbit.cyou/extra/kisslicer/bt ... .gcode.zip

[pjr]

Very strange.

There appears to be a Travel/Iron Path in the middle of a support print...

Capture.JPG (68.6 KiB) Viewed 402 times

Will pass this on.

[pjr]

Any chance you can upload the model so I can test further?

Thanks

Peter

[yrabbit]

Yes, this is the model file.

And its descendant printed from silk plastic (using KISSlicer ofc), redesigned so that it does not require supports

enclosure.jpg (3.73 MiB) Viewed 397 times