Ironing

Post Reply
Oleg
Posts: 16
Joined: 05 Nov 2017, 04:53

Ironing

Post by Oleg »

I'm not sure there is such a setting. During ironing, part of the filament flows out of the nozzle. After ironing and continuing printing, additional filament feeding is required. If this is not done, strong underextrusion is observed at the beginning.
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Ironing

Post by pjr »

Yeah, it looks like there is a fault there.

There is a destring (suck) both before and after the ironing and then only a single destring (prime).

Reported and will be looked into shortly.

Peter
Post Reply