3D Touch still running in 2020!

Post Reply
User avatar
Posts: 6
Joined: 14 Nov 2014, 02:04
Location: QLD, Australia

3D Touch still running in 2020!

Post by Deep_Orange »

Hey, you might find this a bit surprising but I am still running my trusty old 3D touch as of June 2020!
The only slicer I use is KISSlicer and cannot fault it. I did start with the BFB slicer, but switched in 2012 (KS-PRO v1.0.7.17) and havent looked back.

I kinda wish this printer would die already so I can justify buying a new one, but it just keeps on going and going and going.

Yea, I have upgraded a few parts:
Aluminium bed arms instead of the flimsy acrylic.
Heated aluminium bed.
E3D hot end.
Overhead filament feed.
Enclosed sides for heat containment.

But the baby still runs.....!
:lol: :lol: :lol: :lol: :lol: :lol:
Posts: 1
Joined: 16 Jul 2020, 10:09

Re: 3D Touch still running in 2020!

Post by falmeida »

Hi. I have one here in Brazil. Could you attach the software and settings files you are using? Thanks
Post Reply