What does this message mean?

[Miatpi]

Hi, I want to print a model with a cubex printer but when I save my bfb CubeItmod gives me this message: "According to fit the lowest Cubex RMP some X/Y speeds are increased by 900%". What does it mean? Is it crucial for my print?

Thanks

[Hugues]

Hi,

It's the repport of cubeitmob modifications. 900% is really hight !

To decrease this try remove the min layer time with "0" and use a prime pillar.

[Miatpi]

Hi,

It's the repport of cubeitmob modifications. 900% is really hight !

To decrease this try remove the min layer time with "0" and use a prime pillar.

I can´t find the "min layer time" setting. Also I wonder if these M227/M228 settings are involved in this problem.

[Hugues]

No, there is no relation with m227/m228.

The min layer time boxe is in the material tab/ fan cool section/ Min Layer [s]

Check if there is a value inside it.

[Miatpi]

No, there is no relation with m227/m228.

The min layer time boxe is in the material tab/ fan cool section/ Min Layer [s]

Check if there is a value inside it.

Ah, it's there. I was searching in the Printer/speed settings. What should I set it to, 20 s?

[Hugues]

No, set 0 and if your model need to be cool down, put a prime pillar

[Miatpi]

No, set 0 and if your model need to be cool down, put a prime pillar

Thanks, but I wonder why I shouldn't that option. Wouldn't the layers slow down using it?

[Hugues]

Cubeitmod adapt the speed to the RPM readable by the cubex. When you activate this function Kisslicer may calculate a really slow RPM and as Cubeitmod convert them in a readable value it increase the speed. It could be (like your case) too much.
The cubex cannot go down 0.1 rpm.

[Miatpi]

Thanks for the help, the error is gone now. Now I still have a problem: my printer is to quick with the printing so my model is prety rough. I have set it to be very precise but it's prints as quick as always. Any thoughts?

[Hugues]

Set all speed to 25, it will be good to have a precise print.