Prusa "original" Mk3 Profiles (single filament)

Prusa "original" Mk3 Profiles (single filament)

Postby pjr » 01 Apr 2018, 07:39

Hi Guys

Having just received and build my Mk3, I have now added profiles to my FTP site. Downloads are available from this page: http://www.kisslicer.com/preconfigured-profiles.html (is currently does not mention the Mk3, but they are there...).

The profiles are set up for Printer, PLA (including Preload and Linear Advance - both set for PR filament), and a variety of styles (including variable layer height) and support. These were generated using firmware 3.2.0 alpha where LA has been re-enabled.

If you have any problems, please let me know.

As soon as the MMU V2 arrives, I will have a look at setting up profiles for that as well.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 301
Joined: 05 May 2015, 10:27
Location: Slovenia

Re: Prusa "original" Mk3 Profiles (single filament)

Postby pjr » 02 Apr 2018, 15:17

FWIW, quick note regarding Linear Advance in firmware 3.2.0 alpha:

Seems that using both Preload and LA has issues. Skipping at start of sector, so it seems to be overloading the extruder or missing steps.

Printing via OctoPrint; sending "M900 K0" during a print immediately stops the extruder skipping.

My feeling is that LA may not be respecting the firmware limits, but I am probably very wrong...

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 301
Joined: 05 May 2015, 10:27
Location: Slovenia


Return to General

Who is online

Users browsing this forum: No registered users and 1 guest