Page 2 of 2

Re: Destring wizard

Posted: 29 Apr 2018, 16:26
by sinned6915
Woody-

Thanks for this thread and posting this picture. It really helps describe the process.

Can you describe the model and settings that you used for the towers?

I can not get 'good' stringing with my setup. I am trying to print 2 perimters/loops with 12.5% infill. I think that the infill is having the effect of 'destringing' the print.

In vase mode, I was getting some strining, but I started loosing bed adhesion ~6-7mm in height and none of them worked out at all.

I have sucessfully temperature tuned, flowrate tuned and preload tuned so far. I just cant seem to get any stringing that will let me judge the effectiveness.

Thanks

Dennis