Page 1 of 1

Pause at a specific Z height

Posted: 14 Dec 2017, 19:40
by RichWP
Hello,

I see in version notes for 1.6:
G-CODE IMPROVEMENTS

There is now a preheat function (saves time when using more than one extruder)
Pause-and-Resume G-code can be triggered either at the top of Void sub-objects, or at specific user-entered Z heights
How/where do I enter the 'specific user-entered Z height'?

Am I interpreting this feature correctly? That is, can use this to pause your print at a given Z height - [change filament, etc.] - then resume the print?

Thanks in adavance for any help.

Re: Pause at a specific Z height

Posted: 20 Mar 2018, 09:48
by pjr
I think you are reading it correctly, but it's not a feature I remember seeing...

Peter