Hi all!
I'm here because i'm a little problem with every release of ks.. The problems are a lot, but i think the very problem is on my settings. I post a picture for a better understend.
The most problems are at the end of layer and when there is a hole.
I use a PRO version of KS 2 rc for widnwos, but i have try with a mac and the problem persists.
Link a photo
Imperfections
- EddyMI3D
- Posts: 81
- Joined: 03 Oct 2015, 17:12
Re: Imperfections
Hello!
This effect is called ringing. You can find information on this here:
http://wiki.malyansys.com/doku.php?id=corner_ringing
http://www.akeric.com/blog/?p=3436
https://www.simplify3d.com/support/prin ... eshooting/
http://www.makerbot.com/blog/2010/11/02 ... ave-durant
https://ultimaker.com/en/community/6536 ... ?page=last
Or just google for "3d printing ringing"
This effect is called ringing. You can find information on this here:
http://wiki.malyansys.com/doku.php?id=corner_ringing
http://www.akeric.com/blog/?p=3436
https://www.simplify3d.com/support/prin ... eshooting/
http://www.makerbot.com/blog/2010/11/02 ... ave-durant
https://ultimaker.com/en/community/6536 ... ?page=last
Or just google for "3d printing ringing"
-
- Posts: 38
- Joined: 08 Sep 2015, 16:50
Re: Imperfections
You have a lot of beer payed!!
Thanks a lot
I can to change the acceleration, beacuse now they are 700 mm/s..I must do same test
Thanks a lot
I can to change the acceleration, beacuse now they are 700 mm/s..I must do same test
-
- Posts: 1
- Joined: 19 Apr 2017, 17:20
Re: Imperfections
I would recommend you to check some proper guides on how to use your 3d printer.
I can be a problem of a concrete model of printer, but first of all take a look at this guide, it may help you a lot : http://3dinsider.com/3d-printing-guide/
Super
I can be a problem of a concrete model of printer, but first of all take a look at this guide, it may help you a lot : http://3dinsider.com/3d-printing-guide/
Super