Cura for BfB printers

Post Reply
Anar
Posts: 16
Joined: 18 Sep 2015, 15:32
Contact:

Cura for BfB printers

Post by Anar »

I know this is a Kisslicer forum but I post here because a discussion was started at KS refugee camp on which we can't post anymore (https://groups.google.com/forum/#!topic ... K8mDJ7h8Tc).
And because on KS refugee camp it says "This forum is moved to another site: Kisslicertalk.com"... So I post it here.

Just being curious, today I have tried Cura (V 15.04) for my old BfB Rapman 3.1 and managed to have a quiet decent gcode file.
But to have a similar Extruder RPM as in KS I had to use a Flow% value of 3725% !!!

Anyone else successfully tried Cura with a Rapman ?
If yes, how did you manage to have a good extruder speed (Flow rate) ?
Post Reply