File Verify Error on 3D touch for KS v1.6 and later
Posted: 06 Apr 2019, 10:08
I'm getting back to using my 3D touch after a couple of years of watching it collect dust.
I just updated to v1.6.3 of Kisslicer and found that that posted code will no longer verify on the 3D touch.
The printer is reporting an error at a line number beyond the end of the file.
The KS v2.x alpha series also fails to verify, but KS v1.5 still generates code that successfully executes.
Has anyone else with a 3D touch run into this? I'm guessing it's likely that I've misconfigured something, but there are not any obvious candidates. I can always start ripping out file sections in order to isolate the problem but would prefer to avoid that if possible ...
Thanks!
I just updated to v1.6.3 of Kisslicer and found that that posted code will no longer verify on the 3D touch.
The printer is reporting an error at a line number beyond the end of the file.
The KS v2.x alpha series also fails to verify, but KS v1.5 still generates code that successfully executes.
Has anyone else with a 3D touch run into this? I'm guessing it's likely that I've misconfigured something, but there are not any obvious candidates. I can always start ripping out file sections in order to isolate the problem but would prefer to avoid that if possible ...
Thanks!