Z Lift in Cubex Trio

Post Reply
User avatar
gastonfama
Posts: 45
Joined: 29 Sep 2015, 12:21

Z Lift in Cubex Trio

Post by gastonfama »

Hello everybody.
I have a Cubex Trio and I am pretty new with the Kisslicer.
Does anybody have any experience with the Z-LIFT parameter?
As far as I know, it is supposed to lift the Z some mm while traveling. If I put the value in CERO the cubex still does some lift, and if I put something exaggerated like 5 mm, it lift a lot the nozzle. That makes me think that the parameter is working but...
Is there any way to disable the lift at all?
Thank you very much.
Regards.
User avatar
gastonfama
Posts: 45
Joined: 29 Sep 2015, 12:21

Re: Z Lift in Cubex Trio

Post by gastonfama »

Hello everybody.
I finally found out that the option Z-Settle in Printer / Hardware also affects that behavior.
Solved.
GiwrgosP
Posts: 2
Joined: 17 Feb 2016, 10:12

Re: Z Lift in Cubex Trio

Post by GiwrgosP »

Hello,
it's been a while since this thread but has anyone managed to deactivate Z-lift on CubeX-bfb firmware?

Regards,
George
Post Reply