Page 1 of 1

Accelerations settings

Posted: 08 Feb 2018, 05:35
by rantzaus
Hi fellow CubeX printers

Is there at way to adjust the acceleration of the movements on the CubeX?
When printing infill, the whole machine is shaking, since the acceleration is high and displacement small.

Any Ideas?

Re: Accelerations settings

Posted: 12 Feb 2018, 16:19
by Giovanni V.
Hi, with Cubex firmware you cant directly control the acceleration, but if you reduce the Max Speed into CubeItMod, the acceleration will be reduced.