Jet (Extruder) Offset Calibration

Post Reply
dang8
Posts: 2
Joined: 07 Jul 2017, 16:47

Jet (Extruder) Offset Calibration

Post by dang8 »

Hello,
I'm slowly working though the calibration of my CubeX Trio and am up to the point of adjusting the jet offset.
I see that there is a file with the .cubex extension that I can download to do it, however, I don't have any of the cartridges with the chip it in. Is there a way to convert this to a file that Kisslicer will understand?

I've attached a picture showing what the printer is doing. This is a 1x1x1" cuber divided into 4 parts.
- Jet 1: White PLA - layers 1 and 4
- Jet 2: Blue ABS - layer 2
- Jet 3: Green ABS - layer 3

As you can see, Jets 2 and 3 are perfect... just Jet 1 is offset from them.
FullSizeRender.jpg
FullSizeRender.jpg (94.18 KiB) Viewed 1180 times
User avatar
pjr
Posts: 692
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Jet (Extruder) Offset Calibration

Post by pjr »

Sorry, I don't know your printer, but I think the settings are in Printer/Extruder Hardware tab:
Image1.jpg
Image1.jpg (109.21 KiB) Viewed 1175 times
Peter
Post Reply