Guide/Manual

Post Reply
obelisk79
Posts: 11
Joined: 29 Aug 2016, 12:27

Guide/Manual

Post by obelisk79 »

Ok, so I've spent the last week searching and reading as much as I can about how to make good prints with the CubeX.

I'm using KISSLicer 1.5 and CubeItMod 6.05.

I've run the setup procedures from cubexupgrade, and done some tweaks of my own hoping to get better prints. When attempting to print 3DBenchy (from thingiverse) I have a lot of problems with pillar twisting, arches/bridging and smaller details. For example, the text on the underside is not clear. The embossed letters on the back are not recognizable at all. The raised edges around the sizes of the doors/holes are not well defined.

I am having a difficult time understanding where the issue lies.

Is there a wiki, guide or manual that goes into better detail how to properly configure the printer? Or how all of the settings in Cuebitmod/KIsslicer work and how each could affect your prints? I don't mind taking time to calibrate my printer, but more than a week trying to figure this out seems a bit excessive.

Very Frustrated!

-Joe
boggieman71
Posts: 6
Joined: 12 Dec 2016, 00:38

Re: Guide/Manual

Post by boggieman71 »

Amen! Well said Sir! Trial and error consumes too many scarce resources.
Post Reply