Cubex Print issue

Re: Cubex Print issue

Postby Giovanni V. » 07 May 2018, 03:19

natholego11 wrote:

well, I started to do this work, and fried the motherboard. so there goes that printer.

Thanks for the help though, It was a good run!



Sorry for that, I had the same problem.
I've changed the hardware, I've installed a Rumba mainboard with Marlin fimware and I'm very happy with it, much more easy to find the good parameters for the filament, the printer is more reliable, no more print errors.
If you want to do the same is not expensive and you can download the firmware I've uploaded into this forum.
Giovanni V.
 
Posts: 239
Joined: 18 Nov 2014, 09:34

Re: Cubex Print issue

Postby airusso2907 » 08 Aug 2019, 14:12

Hello, i have a similar problem with m227 values i think, the start of the path is always wrong like the motor is not pulling the filament
take a look at the attached picture, some help please?
Attachments
67657019_1282972238551016_2829568709947817984_n.jpg
67657019_1282972238551016_2829568709947817984_n.jpg (27.78 KiB) Viewed 57 times
68728390_879823782394161_8650546055244414976_n.jpg
68728390_879823782394161_8650546055244414976_n.jpg (36.23 KiB) Viewed 57 times
airusso2907
 
Posts: 1
Joined: 13 Feb 2015, 11:25

Previous

Return to 3D Systems: Cubex, Cubepro etc.

Who is online

Users browsing this forum: No registered users and 2 guests