Page 1 of 1
Good impressions in Ender 3!
Posted: 10 Feb 2019, 05:35
by ismaelzsilva
Hi! After a few tips of @pjr i have been able to print in a decent print quality.
0.2 layer thick, infill 10%(?)m and some tweaks. When i finish configuring Kisslicer i will post the configurations in the Hardware subforum.
Check the pictures:
Re: Good impressions in Ender 3!
Posted: 10 Feb 2019, 08:12
by pjr
YAY!!!
Aztech Chief.
There's also a nice multi-filament version which I printed a long time ago
That's brilliant, well done. You should be able to print this model without either the prime tower or brim.
Peter
Re: Good impressions in Ender 3!
Posted: 10 Feb 2019, 13:34
by ismaelzsilva
pjr wrote:YAY!!!
Aztech Chief.
There's also a nice multi-filament version which I printed a long time ago
That's brilliant, well done. You should be able to print this model without either the prime tower or brim.
Peter
Thnx! I was wondering if the prim tower can be resized or configured, or it is fixed?
Re: Good impressions in Ender 3!
Posted: 11 Feb 2019, 04:44
by pjr
ismaelzsilva wrote:I was wondering if the prim tower can be resized or configured, or it is fixed?
I don't believe that you need the Prime Tower at all. That is used to prime the nozzle (ie during a tool change) and can be turned off (set to "No Prime Structure") for single filament prints.
Peter