Chequered Octopus

Chequered Octopus

Postby pjr » 13 Oct 2017, 13:21

IMG_20171013_201839.jpg
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 452
Joined: 05 May 2015, 10:27
Location: Slovenia

Re: Chequered Octopus

Postby EddyMI3D » 13 Oct 2017, 15:23

Peter - this one is awesome!
User avatar
EddyMI3D
 
Posts: 81
Joined: 03 Oct 2015, 17:12

Re: Chequered Octopus

Postby mhackney » 13 Oct 2017, 15:53

Super Duper Peter!
User avatar
mhackney
 
Posts: 147
Joined: 25 Jan 2015, 10:48

Re: Chequered Octopus

Postby pjr » 13 Oct 2017, 16:02

Thanks guys. 8 hours at 0.2mm layers; I also printed the original (https://www.thingiverse.com/thing:244927) with variable layers (0.8 to 0.2) in 2 colours: 14 hours.

IMG_20171011_113037.jpg


The wipe towers are bigger than necessary; I just allowed a regular 50mm purge per filament and on the 4C model, there were 3 layers which came out at 2 changes due to filament ordering.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 452
Joined: 05 May 2015, 10:27
Location: Slovenia


Return to Gallery

Who is online

Users browsing this forum: No registered users and 1 guest