Too many loops plus crown in a narrow wall

Post Reply
Beefeater
Posts:34
Joined:17 Jul 2017, 22:54
Too many loops plus crown in a narrow wall

Post by Beefeater » 11 Dec 2018, 21:18

Overextrusion.jpg
I did not make a separate example, but we can see the problem in the attached model near X1.407 Y29.416 Z4.767. Part of the cross-section is too narrow for two loops, but KS makes two loops anyway, which is already an over-extrusion.Then on top of that, it puts a crown bead there, too. Altogether, the wall gets about twice the amount of material it should. Happens in both KS 1.6.3 and 2.0.4.4.
You do not have the required permissions to view the files attached to this post.

User avatar
pjr
Posts:612
Joined:05 May 2015, 10:27
Location:Kamnik, Slovenia

Re: Too many loops plus crown in a narrow wall

Post by pjr » 12 Dec 2018, 03:42

I have reported a crown path problem with multiple filaments which is being worked on.

This is now also reported.

Thanks

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.

Post Reply