Z-Band to thick

Locked
dorbar
Posts: 12
Joined: 01 Sep 2016, 15:34

Z-Band to thick

Post by dorbar »

Hi there
I'm not sure if this is a "proper bug" or just a feature as is. As far as I understand the Z-Band determines the last few layers before a support touches the overhang part being printed, right?! Well that few layers are 5 mm thick, no matter how thick is the layer. I tried with 0,25 and 0,5mm but I've got 5mm of Z-Band. This is VERY, very annoying as the support is extremely difficult to remove. Please look at the picture bellow. And they are usually 50% solid... so very hard to remove. No matter what I set 0 or 1 or 0.5 the thickness is always the same. BUT I can increase it up to 10! Which is really a nonsense.

Could someone check that?

Thanks,
D.
Z-Band.jpg
Locked