Is the circular infill pattern the same as the octagon?

Is the circular infill pattern the same as the octagon?

Postby K.Miya » 10 Oct 2019, 05:30

Hellow!

I was looking at each infill pattern, but I couldn't find the difference between the circular infill pattern and the octagonal infill pattern.
There is a possibility of the same process.
K.Miya
 
Posts: 15
Joined: 16 May 2017, 20:58

Re: Is the circular infill pattern the same as the octagon?

Postby K.Miya » 10 Oct 2019, 05:41

I'm sorry, the Circular infill pattern is a rounded infill pattern.
K.Miya
 
Posts: 15
Joined: 16 May 2017, 20:58

Re: Is the circular infill pattern the same as the octagon?

Postby pjr » 10 Oct 2019, 09:10

I have never been able to tell the difference either, but I think it depends on the type of printer in use and whether that printer is able to use the G2 command.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 598
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Is the circular infill pattern the same as the octagon?

Postby K.Miya » 11 Oct 2019, 01:44

Thank you Peter
It seems that the pattern I used was too small to make a difference.
It is not reflected in the path view.

K.Miya
K.Miya
 
Posts: 15
Joined: 16 May 2017, 20:58


Return to Bug reporting

Who is online

Users browsing this forum: No registered users and 1 guest