Grid do not take in account the brim diameter

Grid do not take in account the brim diameter

Postby Olivier13 » 21 Jun 2017, 10:57

Hi

In KS 1.5 RealeseIf you use grid + (large) brim option with multiple objects/Island, islands grids cross themselves : the grid do not take in account the brim diameter.
To avoid : use "Inflate Raft..." option to correct...but you will see your prime pillar growing as well :(
Regards

...is there anybody (Jonathan) out there?
Printer : A4v3 From 3ntr - 2 Extruders.
http://www.additec.fr
User avatar
Olivier13
 
Posts: 43
Joined: 29 Jun 2015, 10:46

Re: Grid do not take in account the brim diameter

Postby pjr » 21 Jun 2017, 13:47

Hi

I have just checked the latest alpha and it does not appear to be an issue in that.

I loaded 2 models, set brim to 10mm and inflate raft to 3mm. After slicing the raft looks just a little more than 3mm outside the brim.

You may want to check it out when the next beta arrives.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 256
Joined: 05 May 2015, 10:27
Location: Slovenia


Return to Bug reporting

Who is online

Users browsing this forum: No registered users and 1 guest