Page 1 of 1

Kisslicer 1.6.2 manual supports

Posted: 09 Mar 2018, 11:26
by Elvis3D
Good morning ! I'm using Kisslicer version 1.6.2! I wanted to give you a suggestion: 1) if it was possible to insert a new function in Kisslicer in order to position the supports manually! Waiting for your response I hope positive Thank you very much for your availability! Romagnoli Alessandro

Re: Kisslicer 1.6.2 Slow speed last outer perimeter

Posted: 09 Mar 2018, 11:29
by Elvis3D
Good morning ! I'm using Kisslicer version 1.6.2! I wanted to expose you a problem
    1) It is happening to me that when it covers the last external perimeter in parts of the object where there is a slope or attached to a hole, it slows down the speed a lot, also creating a deburring where there is a hole like an excess extrusion! Could you tell me how to exclude this forced slowdown?
  Waiting for your response I hope positive Thank you very much for your availability! Romagnoli Alessandro