Kisslicer 1.6.2 manual supports
-
- Posts: 2
- Joined: 29 Jun 2016, 08:57
Kisslicer 1.6.2 manual supports
Good morning ! I'm using Kisslicer version 1.6.2! I wanted to give you a suggestion: 1) if it was possible to insert a new function in Kisslicer in order to position the supports manually! Waiting for your response I hope positive Thank you very much for your availability! Romagnoli Alessandro
Last edited by Elvis3D on 09 Mar 2018, 11:30, edited 1 time in total.
-
- Posts: 2
- Joined: 29 Jun 2016, 08:57
Re: Kisslicer 1.6.2 Slow speed last outer perimeter
Good morning ! I'm using Kisslicer version 1.6.2! I wanted to expose you a problem
1) It is happening to me that when it covers the last external perimeter in parts of the object where there is a slope or attached to a hole, it slows down the speed a lot, also creating a deburring where there is a hole like an excess extrusion! Could you tell me how to exclude this forced slowdown?
Waiting for your response I hope positive Thank you very much for your availability! Romagnoli Alessandro
1) It is happening to me that when it covers the last external perimeter in parts of the object where there is a slope or attached to a hole, it slows down the speed a lot, also creating a deburring where there is a hole like an excess extrusion! Could you tell me how to exclude this forced slowdown?
Waiting for your response I hope positive Thank you very much for your availability! Romagnoli Alessandro