Support for Bridge Settings

Re: Support for Bridge Settings

Postby inventabuild » 20 Nov 2018, 09:29

Hello Peter,

Thanks for testing.

1. Does it make sense that 1.7 does better than 2.0?
2. Will 1.7 adversely affect top surface quality vs something like 0.2?
3. It seems to me bridging needs to be fixed in KISSlicer. Is this something Jonathan is working on?
inventabuild
 
Posts: 265
Joined: 09 Nov 2014, 23:03

Re: Support for Bridge Settings

Postby pjr » 20 Nov 2018, 10:38

Hi.

1. Yes, I think it does. Too much overlap is as bad as too little.
2. Yes, but using 0.2 for the top surface really doesn't seem enough.
3. It's on the fault list (rather than wish list); I can't really say any more (only because I don't know :( )

There is something not right with the overlap settings, and that is also on the fault list, so I hope Jonathan will get round to it asap.

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 482
Joined: 05 May 2015, 10:27
Location: Kamnik, Slovenia

Re: Support for Bridge Settings

Postby Calakuta » 27 Nov 2018, 05:19

I'm super excited I stumbled on this topic.... It's been my major concern for some time now
Calakuta
 
Posts: 2
Joined: 27 Nov 2018, 04:09

Previous

Return to Feature requests

Who is online

Users browsing this forum: No registered users and 1 guest

cron