More free parameters for post-processing

Re: More free parameters for post-processing

Postby pjr » 10 May 2018, 05:21

I believe that the parameters you require should be OK in the Prefix section (I haven't tested them all though). However, If not, then I suggest you try "Selecting and Warming Extruder" ("Select New Ext & Warm" G-code section).

Peter
Please note: I do not have any affiliation with KISSlicer. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss.
User avatar
pjr
 
Posts: 301
Joined: 05 May 2015, 10:27
Location: Slovenia

Previous

Return to Feature requests

Who is online

Users browsing this forum: No registered users and 2 guests