delta

Post Reply
gorf26
Posts:1
Joined:09 Nov 2018, 18:47
delta

Post by gorf26 » 20 Oct 2020, 15:54

I have a delta printer and seems like i am getting jagged edges around circles and half circle, don't know if you can see from the attached pic...
i am using kiss v2.. i can't seem to figure out a setting to help with this problem, i have sliced the same file in SuperSlicer and i get good circles so i figure it's not a firmware or hardware problem.. also it a duet wifi board..

looking at it while printing with kiss it looks like as its moving around the circle it stopping then moving all the way around the circle hence the jagged circle..

also it printed in petg..

Thanks gary

Post Reply