Why is this happening?

Post Reply
Cameluntu
Posts: 8
Joined: 16 Sep 2019, 03:35

Why is this happening?

Post by Cameluntu »

A word is worth a thousand words.

Why am i getting this?Or at least what should i check? I have looked everywhere, seam is in the middle section. I have tried preload = to 6 and = to 0.75 (for science) and i get similar results.

photo5782835476363850036.jpg
photo5782835476363850036.jpg (119.7 KiB) Viewed 694 times
photo5782835476363850037.jpg
photo5782835476363850037.jpg (81.03 KiB) Viewed 694 times
Thank you in advance for any help!!!
User avatar
ksh_germany
Posts: 48
Joined: 11 May 2019, 04:56
Location: Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany »

Hello,
i think it will come from wipe or Unload Setting you're using alpha 1.6.3?
because there is an issue with unload Settings, take a look viewtopic.php?f=5&t=4744&start=10#p10602
Cameluntu
Posts: 8
Joined: 16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu »

Thanks for your reply! However i have tried disabling unload and wipe, results are similar. I'll download v1 and see if i get the same issue.
User avatar
ksh_germany
Posts: 48
Joined: 11 May 2019, 04:56
Location: Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany »

Please send gcode, for Research.
Cameluntu
Posts: 8
Joined: 16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu »

This is the very last one with unload set to 50mm, i would need to print another one without unload if you want to dive into it.
NuovoKisslicer.rar
(1.98 MiB) Downloaded 48 times
Cameluntu
Posts: 8
Joined: 16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu »

i think i found the issue comparing my different printers. PreloadVE and Linear Advance dont like each other (probably for obvious reasons), disabling PVE would not generate the issues above.
Cameluntu
Posts: 8
Joined: 16 Sep 2019, 03:35

Re: Why is this happening?

Post by Cameluntu »

Apparently it's not even that, so gl kisslicer and welcome prusa slicer . Cheers
User avatar
ksh_germany
Posts: 48
Joined: 11 May 2019, 04:56
Location: Siegen, NRW, Germany

Re: Why is this happening?

Post by ksh_germany »

:shock: nice to know thanks for telling your experience
Post Reply