Page 1 of 1

Kisslicer from command line on windows

PostPosted: 25 Jun 2019, 02:10
by masterofreality
Hello.
I'm using Kisslicer for automation slicing process of 3d printing small factory.

I Run kisslicer from console in windows from external application service. (with -hidegui and etc arguments )

Please! Tell me, How can i ignore this message programmaticaly (without pressing the button) for ex. is there are settings or any workaround ?

Image

Thank you

Re: Kisslicer from command line on windows

PostPosted: 25 Jun 2019, 02:43
by pjr
Could you not simply open the Settings/Misc tab and increase the RAM Warning to something more sensible?

Capture.PNG
Capture.PNG (26.52 KiB) Viewed 591 times


Peter

Re: Kisslicer from command line on windows

PostPosted: 25 Jun 2019, 03:09
by masterofreality
Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?

Re: Kisslicer from command line on windows

PostPosted: 25 Jun 2019, 09:44
by pjr
masterofreality wrote:Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?


Yeah, I thought that may be the case. Just checking. Hopefully I will have a response shortly.

Peter

Re: Kisslicer from command line on windows

PostPosted: 24 Jul 2019, 10:45
by pjr
This is now on the fault list and will be included in a future release.

Peter