kisslicertalk.com

Hello.
I'm using Kisslicer for automation slicing process of 3d printing small factory.

I Run kisslicer from console in windows from external application service. (with -hidegui and etc arguments )

Please! Tell me, How can i ignore this message programmaticaly (without pressing the button) for ex. is there are settings or any workaround ?



Thank you

Could you not simply open the Settings/Misc tab and increase the RAM Warning to something more sensible?
Peter

Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?

masterofreality wrote:Unfortunately no (
Because if RAM warning value more than real RAM , this value is igonring. I was thinking that in nogui mode should not be any windows.
Or May be can set this value in config file?

Yeah, I thought that may be the case. Just checking. Hopefully I will have a response shortly.

Peter

This is now on the fault list and will be included in a future release.

Peter