Filament Calibration - Hatchbox PLA

Abom
Posts: 10
Joined: 15 Jun 2019, 12:39

Re: Filament Calibration - Hatchbox PLA

Post by Abom »

I went thru some pretty extensive testing with my old slicer, Cura 4.0 and PETG. After nearly eliminating it all together, the final piece of the puzzle was increasing the travel speed. I run it almost flat out at 230mm/s and stringing is gone. Seems to do the trick in KISS as well. Now if I can just get the seams to blend properly...
Post Reply