Page 1 of 1
%infill Not Working
Posted: 18 Mar 2019, 22:12
by jimboh2
I am using 1.6.3 and when I type a value into %infill (either 70 or 70%) and hit ok Nothing happens. It stays at the value it was previously set at with the slider. I want 70% and all I can get with the slider is 50% or 100%.
Is it a bug?
Re: %infill Not Working
Posted: 18 Mar 2019, 22:18
by jimboh2
OK I see it is working but it selects a size somewhere near what I enter. So if I enter 15 it will give me 12.5%.
Does that mean there is no value in using 70%? I should use either 50% or 100%?
Re: %infill Not Working
Posted: 19 Mar 2019, 03:32
by pjr
I think you will find that setting infill manually changes 2 settings:
Infill percent
Infill extrusion width
The percent must be able to be divided into 100; the extrusion width makes up the difference.
Peter
Re: %infill Not Working
Posted: 19 Mar 2019, 09:30
by jimboh2
Ah yes I see that now. Thanks for the quick explanation.